New Server

[mjburgoyne1]

What do I need to do to log onto the new server?

[Jens]

Hi!

You need Swift, becaise X-IvAp is not longer supported.

Here is a guide how to do:

https://drive.google.com/file/d/19J32w9 ... Ul1Oe/view

If you should have any problems with Swift, please contact us

[mjburgoyne1]

I have upgraded to Swift. When I tried to fly today, Swift would disconnect saying my frame rate was too low. I tried setting my graphics to the lowest setting. Swift keep disconnecting me. Where can I find more information on how to setup x-plane to function with Swift?

[mjburgoyne1]

I've read information on x-plane.org on increasing the fps rate. I'll try it out and see if I can remain connected. I'll try it 03/08/22. I'll let you know if I succeeded or not.

[Jens]

Hi Mike,

could you please tell us about your system specs?

[mjburgoyne1]

Hi Jens,
Here is the Hardware Overview:

Model Name: iMac
Model Identifier: iMac18,2
Processor Name: Quad-Core Intel Core i7
Processor Speed: 3.6 GHz
Number of Processors: 1
Total Number of Cores: 4
L2 Cache (per Core): 256 KB
L3 Cache: 8 MB
Hyper-Threading Technology: Enabled
Memory: 16 GB
System Firmware Version: 447.80.3.0.0
OS Loader Version: 540.80.2~11
SMC Version (system): 2.40f1
Serial Number (system): C02XR085J1G9
Hardware UUID: 2D7B1287-490F-5066-A910-1FBBF69616FE
Provisioning UDID: 2D7B1287-490F-5066-A910-1FBBF69616FE

I have two additional Monitors.

I was able to fly from KEKO to KOGD today. I took one monitor off the sim and put Swift on it so I can monitor it.

I'll get the sim settings in a few minutes.

[mjburgoyne1]

Screen Shot 2022-03-08 at 1.46.12 PM.png (245.95 KiB) Viewed 15119 times